华灿兴科技版权所有® 2010-2025 粤ICP备10101563号
SD Card Control Mode
Step 1. Connect controller to lights
Assume you have a roll of 5m strip, 1m 30 pixels, WS2812B, RGB(color order)
Step 2. Program with LED Build
please watch the video above, or you can watch the video post below
Internal Control Mode
In this mode, controller needs to know
(1). pixel number
(2). how pixels are connected
(3). clock rate
(4). chip model
(5). controller type
(6). color order
Still, we take one roll 5 meters WS2812B strip for example. Color order: RGB. 1m 30 pixels
Step 1. Make file needed for this mode in LED Build
Step 2. Put the file into SD card, insert SD card, power controller on then off, take SD card out, power controller on
Step 3. Connect them all together
There are 18 kinds of animation built-in, press four buttons to control them.
DMX512 Console Mode
In this mode, H801SB only supports the following chips
LPD6803, LPD8806, LPD1882, LPD1889, LPD1883, UCS6909, UCS6912, UCS1903, UCS1909, UCS1912, WS2801, WS2811, WS2812, TM1803, TM1804, TM1809, TM1812, TM1913, TM1914, TM1926, TM1814, INK1003, LX1003, LX2003, LX2006, TLS3001, P9813, P9816, SM16711.
Multiple H806SBs work in synchrony mode
In this mode, every controller needs sd card
8. Set address for DMX512 chips
(1). In this mode SD card is not necessary.
(2). Press "LOOP/SINGLE" + "SPEED+", then loose them all, lights will turn white then green, which means address is successful.
(3). Only after lights are repowered is address updated.
(4). H801SB can address for maximum 1024 pixels.